Pullman Holt GB1400E Manual de usuario descargar pdf (Pagina 8)

PREPARING THE MACHINE

3. CONNECTING THE MACHINE

1. Connect the extension lead to the plug on the handlebars

2. Block the extension lead to the cable-holder handle in front of the handlebars

3. Connect the extension lead to the wall socket

ATTENTION: before connecting the extension lead to the socket,

check the switches are in the off (“0”) position!

4. FIXING THE HANDLEBARS

For packaging purposes the handlebars are supplied folded; they must now be put in the

working position. Proceed as follows:

1. Lift the handlebars, pulling the lever (indicated by the arrow) upwards

2. The machine is now in working position

ATTENTION: Always use low foam detergent. Introduce a small

amount of anti-foam detergent in the recovery tank before start to work

to be sure to prevent foam from being generated. Never use pure acids.

5. DETERGENT SOLUTION

Fill the solution tank with clean water at a temperature that does not exceed 122°F. Add

liquid detergent in the proper concentration and according to the procedures of the

manufacturer. Use only a minimal percentage of detergent to prevent formation of an excess

amount of foam since too much foam may damage the suction motor.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 17 18

Sin comentarios

Pullman Holt GB1400E Manual de usuario Pagina 8