Pullman Holt GB1400E Manual de usuario

GB1400E - electric floor scrubberOperation & Care InstructionsSave For Future Reference

11OPERATION 1. PREPARING TO WORK The following procedures must be done before installing the tanks: 1. Check the switches are in the off (“0”)

1212OPERATION 3. FORWARD MOVEMENTS T

13AFTER THE WORK IS TERMINATED 6 . Move the machine to the place provided for draining the water 7. Detach the tubes and remove the recovery t

14DAILY MAINTENANCE ATTENTION: Disconnect the power cable from the main socket before carrying out any maintenance operations. 1. CLEANING T

15DAILY MAINTENANCE 3. REPLACING THE SQUEEGEE RUBBERS Check the condition of the squeegee rubbers. Replace as necessary.To replace the rubbers:

16SCHEDULED MAINTENANCE 1. CLEANING THE SQUEEGEE TUBE Check the squeegee tube for clogging if the suction is insuffiecient or at periodic inter

17TROUBLESHOOTING 1. ELECTRICAL SYSTEM SAFETY The machine has a thermal trip unit with manual reset. The brush motor is reset by resetting the

18BRUSH SELECTION AND USE POLYPROPYLENE BRUSH (PPL) These are used on all types of floors and offer good resistance to wear and to hot water (not m

LIMITED WARRANTY This scrubber is warranted for 1 year from the date of purchase as shown on your distributor's invoice. Parts not covered under

TABLE OF CONTENTS RECEIVING THE MACHINE...

Receiving the machine ForewardImmediately check, when receiving the machine, that all the materials indicated on delivery documents have been re

W 480 width Rear squeegee widthin 14in 17 Brushes (diameter or length) in 14Brush revolutions rp

6SYMBOLS USED ON THE MACHINE Tap symbol Used to indicate the solenoid valve switch Voltage symbol Used to indicate the machine's voltage

7GENERAL SAFETY REGULATIONS Follow these instructions carefully to avoid harm to the operator and damage to the machine.  Read the labels on the

8PREPARING THE MACHINE 1. HOW TO UNPACK THE MACHINE 1. Open the packaging on the side indicated. 2. Take the machine out of its packaging. 2.

9PREPARING THE MACHINE 3. CONNECTING THE MACHINE 1. Connect the extension lead to the plug on the handlebars 2. Block the extension lead to

10PREPARING THE MACHINE 6. RECOVERY TANK Make sure that the recovery tank is properly inserted in its housing and that the tubes areproperly ins